pasterrealtime.blogg.se - Tis 2000 software

TIS 2000 SOFTWARE HOW TO
TIS 2000 SOFTWARE SOFTWARE
TIS 2000 SOFTWARE CODE

Switch on Tech 2 – start screen appears.

After the closing of the SPS application the TIS 2000 start screen is again displayed. Finally, switch off the Tech 2 and disconnect it from the pc.

The window ‘Transfer Data’ is displayed. A bar shows the progress of the download.Īt the end of the download, a window is displayed with the request to connect the Tech 2 to the vehicle in order to finish the programming process.

TIS 2000 SOFTWARE SOFTWARE

Note: It is not possible to reprogram an ECU with the same software version. A new window displays a “Summary” (follow below) with the selected data. Continue with ‘Next’. Select “Reprog” button to download the latest calibration data onto the TechII diagnostic tool.Validate vehicle data and, if necessary, change with the pull-down menus.Confirm VIN or, if necessary, enter correct VIN, then select ‘Next’.Connect Tech 2 to the pc, switch it on, and click on ‘Next’ on the pc.Follow the instructions on the Tech 2. Then press “Exit” on the Tech 2, switch it off and disconnect it from the vehicle.

TIS 2000 SOFTWARE HOW TO

During the Request Info the Tech 2 receives information from the selected device. If the ECU was replaced a “Request Info” has to be performed for the NEW unit. Since the new ECU is not programmed on delivery, the retrieved information is not complete. For that reason, TIS 2000 gives instructions as how to enter the missing vehicle data.

Note: Depending on the model year and the selected model either a reprogramming of the ECU (F0: Engine) or of the TCM (F1: Transmission) can be selected.

For the selection of “Next” the vehicle has to be identified as requested by Tech 2.

If Tech 2 has already stored vehicle data they will be displayed now. In that case, Tech 2 asks you to either use the current data (hold data) or request further information from the ECU (continue).

Select “F1: Service Programming System (SPS)” in the main menu.

Turn ignition to ON without start the engine!!!.

Connect Tech 2 scanner to vehicle. Power on device – “Tech 2” is displayed on the screen, then press “ENTER”.

On ‘Select Diagnostic Tool and Programming Process’ (picture below) screen make the desired selection forĢ) the reprogramming of an ECU that was not exchanged or the replacement/programming of a new ECU Select the application ‘Service Programming System’ on the TIS 2000 start page.Ĥ.To register the hardware key select ‘Hardware Key Registration’ in the menu ‘Configuration’. Hardware keys that have already been registered are still valid!

TIS 2000 SOFTWARE CODE

Note: The hardware key (HWK) has to be registered prior to working with ‘Service Programming System’. To register a hardware key, the form that is enclosed with the hardware key kit has to be filled in and sent to the address at the top. In case the form is missing, the document is also in the TIS 2000 newsletter (see icon in the TIS 2000 tool bar). At first, the user receives a temporary code until the key is registered on the next TIS 2000 CD. If you need to program Saab ECU, you had to use Saab TIS2000 and USB dongle. TIS2000 will not work on 2007 up GM, and software must work together with TIS2000 USB key.

Here is the step-by-step instruction on programming GM (General Motors) ECUs with Tech2 scanner and SPS (Service Programming System) application in TIS2000.īefore using the SPS, make sure that the Tech 2 scan tool and the pc contain the latest software, the battery of the vehicle is fully charged, only the ignition is on power, and all cables are connected properly.